IMT-600N Injector Cleaner is an advanced electro-mechanical product, which can clean and test injectors by simulating engine working conditions. It can also perform cleaning on the injectors and fuel supply system on vehicle.
Direct/Reverse Flush
Ultrasonic cleaning
To perform simultaneous cleaning on several injectors and to remove the carbon deposits on the injector completely.
Uniformity/Sprayability test
To test the uniformity of injecting amount of each injector, and to monitor the spraying status of each injector with the help of backlight. This test is also for reverse flush.
Leakage test
To test the sealing and dribbling conditions of injectors under system pressure.
Injecting flow test
To check the injecting amount of the injector in 15 seconds of constant injection.
Automatic test
To test injectors by simulating different working conditions.
Electronic-controlled drain system
The unit is equipped with electronic-controlled drain system, for easier empty the cleanser oil tank and clean the tank.
Voltage: AC220V / AC110V
Input Power: 200W
Ultrasonic cleaner Power: 100W
Pressure: 0 ~ 7 Bar
Accuracy of tube: 2%
RPM range: 0 ~ 9999 RPM, step: 10 RPM
PW range: 0.1 ~ 30 ms, step: 0.1 ms
Timing: 1 ~ 30 minutes
Display: LED
Product Flyers, Information, Demo video/software are available in member area.
Cost efficient solution of wheel alignment with dual monitor for easiness of operation under the...
ATM series automatic transmission fluid exchanger,with dynamic heat exchange to suit low temperature working...
Leslie