IMT-600N Injector Cleaner is an advanced electromechanical product, which can clean and test injectors by simulating engine working conditions. It can also perform cleaning on the injectors and fuel supply system on vehicle.
To perform simultaneous cleaning on several injectors and to remove the carbon deposits on the injector completely.
To test the uniformity of injecting amount of each injector, and to monitor the spraying status of each injector with the help of backlight. This test is also for reverse flush.
To test the sealing and dribbling conditions of injectors under system pressure.
Injecting flow test:
To check the injecting amount of the injector in 15 seconds of constant injection.
To test injectors by simulating different working conditions.
On-vehicle cleaning (Optional):
The unit is equipped with various adaptors and couplers that facilitate cleaning on the injectors on vehicle.
Electronic-controlled drain system :
The unit is equipped with electronic-controlled drain system, for easier empty the cleanser oil tank and clean the tank.
AC220V / AC110V
Ultrasonic cleaner Power:
0 ~ 7 Bar
Accuracy of tube:
0 ~ 9999 RPM, step: 10 RPM
0.1 ~ 30 ms, step: 0.1 ms
1 ~ 30 minutes
Durable and energy saving LED backlit.
On-top Cleanser refill
On-Top cleanser oil refill inlet, convinient for frequent use of the equipment.
Easy-to-Operate Control Panel
Clear and easy to operate control panel.
Cooling fan inbuilt to help cool the system down.
Oil drain outlet
Considerate design for drain used cleanser oil. (Electronic Controled)
Loose design of PCB
Injector cleaner generate much heat in operation, loose design of PCB assure better heat release.